Stratasys uPrint (Plus) (SE) EEPROM Writer Refiller V2

Description

This device was designed to be able to rewrite Stratasys eeprom chips that are used in the uPrint, uPrint Plus, uPrint SE and uPrint SE Plus line of 3D printers. The included software (Windows program) will allow you to change material type and material quantity on these chips therefore letting you use any 3rd party filament on your machine at a fraction of OEM costs. This works on stock machines, no tweaks/changes are required.
To rewrite an EEPROM chip, you will need to load the cartridge into the printers bay and use the supplied cable to connect your PC to the printer using the service port in the rear. The software will then let you change the material quantities in each bay.
** NOTE: The chips on the uPrint go into read only mode when the material quantity reaches 0% and cannot be rewritten, so you will need to refill the chips before they're fully empty. We have had a couple of issues where this device/software can corrupt your chip, so do not use it unless your chip is already close to being empty so that you do not lose a chip that still has life left on it. If you are one of the few where the device does not work on your printer we will offer a full refund so buy with confidence.
Tested machine compatibility:
uPrint
uPrint Plus
uPrint SE
uPrint SE Plus
* These units are made to order, please allow a few days for testing and shipping.