3D Systems Cube 3rd Generation Printer Open Source Direct Feed PLA and OEM ABS

Description

*Available in Grey or White (auction is for one printer only)*
**I received some questions related to the print quality of this 3d printer so I felt a simple demonstration of what it could handle would answer those best - please see picture 1. The same print file used to print that bust will be included on the USB stick.**
This is a high quality printer that is kid friendly and easy to use. A 32 bit controller board (same board used in CubePro), .35mm print nozzle, bowden print feed system, maximum print resolution of 70 microns (.07mm) and linear rails on all three axis makes this printer a tremendous bargain. Don't spend more money on a knock-off 3D printer with cheap components. Just upgrading that knock-off printer with quality linear rails will cost more than this printer. 3DSystems mistake was only offering closed source material cartridges and charging extremely high prices for them (much like inkjet printer manufacturers) but... they made
VERY
high quality printers that stand toe to toe with top and far more expensive printers on the market today.
The OEM slicer is closed source but fully capable and easy to use (the 3DBenchy prints pictured were sliced with OEM software at a resolution of .2mm)
Simplify3D
is recommended and profiles for PLA, ABS, PETG, clear PETG and other specialty filaments are included on the 2GB USB drive
Simplify3D will allow you to print ANY filament with a recommended print temp of 265c or lower
Refurbished 3DSystems Cube 3rd Generation 3D printer converted to open source, which allows unlimited re-use of cartridges. The printer has a print volume of ~6" x 6" x 6" (150mmx150mmx150mm). The PLA cartridge has been converted to the B2B design (print3dforum.com) and is fully loaded with new non-OEM PLA (your choice of limited colors available as standard or silk). The ABS cartridge is brand new and unopened - choose between red, yellow and silver ABS. Refurbished cartridges are also available for either non-OEM PLA or 3DSystems ABS. I also offer OEM style PLA cartridge loaded with new non-OEM filament if preferred.
The B2B (Back-2-Basics) conversion, designed by TommyDee of print3dforum.com, allows for much easier loading and swapping of filament. T
he outer shell of the cartridge is modified to allow you to easily feed your favorite filament externally after using up the spool (or reload the cartridge using the included spool reload models).
Includes:
PLA cartridge (converted to B2B design) loaded with new non-OEM filament in your choice of either
Standard PLA in black, white, or grey
Silk PLA available in white, silver or gold (may require minor temperature adjustments with cube3editor tool for best quality)
Brand new genuine 3DSystems ABS cartridge in your choice of red, yellow or silver
New 2GB USB drive that includes 750MB of software, open source tools (decoders, encoders, Simplify3D profiles, etc.) multiple firmware versions and print models (including all B2B components and cartridge reload tools)
New PLA  and ABS glue sticks (Avery -or- Elmer's purple and Elmer's Extreme)
Upgraded print bed surface (resurfaced OEM is also available)
2" scraper
*I
BUY and REPAIR
all makes of 3DSystems 3D printers*
(Sell me your broken printer and I'll sell you a refurb)
*
SELL
me your spent or non-working 3DSystems printer cartridges*